Rohde & Schwarz FPC Series User Manual

Function Reference
R&S
®
FPC
368User Manual 1178.4130.02 ─ 07
Remote command:
CALibration<n>:STARt? on page 230
Normalization S21
See "Activating correction" on page 57.
Remote command:
not supported
20.4.11 Frequency Menu
Access: [Freq]
Center Frequency....................................................................................................... 368
Center Freq Step Size.................................................................................................368
Start Frequency...........................................................................................................368
Stop Frequency...........................................................................................................368
Frequency Offset.........................................................................................................368
Frequency Mode......................................................................................................... 368
Center Frequency
See "Defining a center frequency" on page 94.
Remote command:
[SENSe:]FREQuency:CENTer on page 248
Center Freq Step Size
See "Defining a frequency step size" on page 94.
Remote command:
Mode: [SENSe:]FREQuency:CENTer:STEP:LINK on page 248
Manual step size: [SENSe:]FREQuency:CENTer:STEP on page 248
Start Frequency
See "Defining a start and stop frequency" on page 97.
Remote command:
[SENSe:]FREQuency:STARt on page 251
Stop Frequency
See "Defining a start and stop frequency" on page 97.
Remote command:
[SENSe:]FREQuency:STOP on page 251
Frequency Offset
See "Defining a frequency offset" on page 95.
Remote command:
[SENSe:]FREQuency:OFFSet on page 250
Frequency Mode
See "Working with channel tables" on page 97.
Function Reference: Spectrum Application

Rohde & Schwarz FPC Series Specifications

General

Brand	Rohde & Schwarz
Model	FPC Series
Category	Measuring Instruments
Language	English