R&S FSH Getting Started
Using the Spectrum Analyzer
Quick Start Guide 1309.6269.12 - 09 58
To measure the harmonic ratio, set the marker on the signal and a delta marker on the
second harmonic.
► Press the MARKER key.
The R&S FSH sets a marker on the trace maximum. The trace maximum
corresponds to the signal.
► Press the "New Marker" softkey.
The R&S FSH activates a delta marker and places it on the next trace maximum.
This corresponds to the second harmonic.
The harmonic ratio is the vertical distance of the marker and the delta marker. The
R&S FSH displays this value in the marker table (see picture above).
To Next Page
Loading...
