Power sensor tour
R&S
®
NRP Series
31Getting Started 1419.0170.02 ─ 18
Further information:
●
For details on configuration, see the user manual.
4.5 LAN PoE interface
Available only for LAN power sensors.
An Ethernet RJ45 connector is used to connect the LAN connector to a local area
network (LAN).
Supply the electrical power over the LAN PoE interface. See Chapter 3.5,
"Powering the power sensor", on page 14.
LAN reset button
The LAN reset button is used for resetting the Ethernet connection parameters of
the power sensor to their default values.
Power over Ethernet status LED
The power status LED shows whether the power sensor is correctly powered over
PoE or not.
Indication State
Green The power sensor is powered over PoE. You can operate it using the
Ethernet interface.
Off Not illumina-
ted
No PoE power is present.
Network status LED
The network status LED shows whether the LAN connection to the network is
established properly or not.
Indication State
Green The power sensor is correctly connected to the network.
It has been assigned a valid IP address, either manually or via DHCP.
Red The power sensor is not connected to the network correctly.
Either the connection is erroneous or the power sensor has not been
assigned a valid IP address yet.
LAN PoE interface
To Next Page
Loading...
