Rohde & Schwarz NRP Series - Ethernet Interface

Remote control interfaces and protocols
R&S
®
NRP Series
47Getting Started 1419.0170.02 ─ 18
R&S NRP power sensor USB product ID
R&S NRP90T 0x026C
R&S NRP90TN 0x026D
R&S NRP110T 0x015A
Table 6-6: R&S NRPxxTWG(N) USB product IDs
R&S NRP power sensor USB product ID
R&S NRP75TWG 0x01D1
R&S NRP75TWGN 0x0294
R&S NRP90TWG 0x01D2
R&S NRP90TWGN 0x0295
R&S NRP110TWG 0x01D3
R&S NRP110TWGN 0x0296
Example:
USB::0x0AAD::0x00E2::100001
0x0AAD is the vendor ID for Rohde & Schwarz.
0x00E2 is the product ID for the R&S NRP8S power sensor.
100001 is the serial number of the particular power sensor.
6.2 Ethernet interface
The Ethernet interface of the R&S NRP LAN power sensors allows you to inte-
grate them in a local area network (LAN).
For remote control via a network, the computer and the power sensor must be
connected via the Ethernet interface to a common network with TCP/IP network
protocol. The TCP/IP network protocol and the associated network services are
preconfigured on the power sensor. Software for device control and the VISA pro-
gram library must be installed on the computer.
Ethernet interface