Operating the Instrument
R&S
®
FPL1000
77Getting Started 1179.4657.02 ─ 10
TRG Trigger source
(for details see "Trigger settings" in the User Manual)
●
EXT: External
●
IFP: IF power (+trigger bandwidth)
●
PSE: Power sensor
●
TIM: Time
●
VID: Video
PA The preamplifier is activated.
"YIG
Bypass"
The YIG filter is deactivated.
GAT The frequency sweep is controlled via the "TRIGGER INPUT" connector.
TDF The specified transducer factor is activated.
75 Ω The input impedance of the instrument is set to 75 Ω.
FRQ A frequency offset ≠ 0 Hz is set.
CWSource:
<level>
Internal generator in operation as independant CW source with specified level
(requires option R&S FPL1-B9).
<"NOR" |
"APX">
/Trk.Gen
Internal generator in operation as tracking generator (requires option
R&S FPL1-B9).
NOR: the measurements are normalized with the results of the internal genera-
tor calibration
APX (approximation): the measurements are normalized with the results of the
internal generator calibration; however, the measurement settings have been
changed since calibration
If neither label is displayed, no calibration has been performed yet or normali-
zation is not active.
For details, see the "Internal Generator" section in the R&S FPL1000 User
Manual.
Changing the Channel Setup Name
The channel setups are labeled with their default name. If that name already
exists, a sequential number is added. You can change the name of the channel
setup by double-tapping the name in the channel bar and entering a new name.
7.1.2 Window Title Bar
Each channel in the R&S FPL1000 display can contain several windows. Each
window can display either a graph or a table as a result of the channel measure-
ment. The window title bar indicates which type of evaluation is displayed.
Understanding the Display Information - Spectrum Mode
To Next Page
Loading...
