Rohde & Schwarz R&S NRP Series User Manual

Preparing for Use
R&S
®
NRP Series
14Getting Started 1419.0170.02 ─ 12
4.6 Connecting to a Controlling Host
As a controlling host, you can use:
●
Computer
●
Base Unit
For operating the power sensor, you can choose from various possibilities. For
details, see Chapter 6, "Operating Concepts", on page 31.
4.6.1 Computer
If the controlling host is a computer, you can operate the power sensor using a
supported software, the web user interface or remote control. For details, see
Chapter 6, "Operating Concepts", on page 31.
► Establish the connection using:
● Host interface
See Chapter 4.6.1.1, "Simple USB Connection", on page 14.
See Chapter 4.6.1.2, "R&S NRP‑Z5 Sensor Hub Setup", on page 15.
● LAN interface, if the power sensor is a LAN power sensor
See Chapter 4.6.3, "Using a LAN Connection", on page 18.
4.6.1.1 Simple USB Connection
All R&S NRP power sensors can be connected to the USB interface of a com-
puter.
Required equipment
●
R&S NRP power sensor
●
R&S NRP‑ZKU cable
Connecting to a Controlling Host

Rohde & Schwarz R&S NRP Series Specifications

General

Brand	Rohde & Schwarz
Model	R&S NRP Series
Category	Accessories
Language	English