Rohde & Schwarz R&S NRP Series - R&S NRP Toolkit for Windows; System Requirements

Operating Concepts
R&S
®
NRP Series
32Getting Started 1419.0170.02 ─ 12
6.1.2 System Requirements
Hardware requirements:
●
Desktop computer or laptop, or an Intel-based Apple Mac
●
LAN interface and equipment for setting up a LAN connection.
See Chapter 4.6.3, "Using a LAN Connection", on page 18.
Supported operating systems:
●
Microsoft Windows versions
– Microsoft Windows Vista 32/64-bit
– Microsoft Windows 7 32/64-bit
– Microsoft Windows 8/ 8.1 32/64-bit
– Microsoft Windows 10 32/64-bit
●
For information on other operating systems, see Chapter 6.1.1, "Versions and
Downloads", on page 31.
6.1.3 R&S NRP Toolkit for Windows
The R&S NRP Toolkit installer for Windows-based systems contains the compo-
nents described in the release notes available at www.rohde-schwarz.com/soft-
ware/nrp-toolkit.
Installing on a computer
1. Start the R&S NRP Toolkit installer on the Windows-based computer.
In the "NRP-Toolkit Setup" dialog, the correct R&S NRP Toolkit version for
your operating system, 32-bit or 64-bit, is already selected.
2. Enable the components you want to install.
● "NRP-Toolkit (SDK)"
The software development kit (SDK) provides programming examples for
the R&S power sensors.
● "IVI Shared Components"
Installs the USBTMC driver. Enabled by default because the installation is
recommended.
See also Table 7-1.
R&S NRP Toolkit