Operating Concepts
R&S
®
NRP Series
35Getting Started 1419.0170.02 ─ 12
●
Device with a supported web browser installed:
– Mozilla Firefox 33 or later
– Google Chrome 36 or later
– Microsoft Internet Explorer 10 or later
– Safari 5.1 or later
Setup
1
4
6
5
3
HOST
INTERFACE
IN: 3 V or 5 V logic
OUT: min. 2 V into 50 Ω
max. 5.3 V
TRIG2
I/0
PoE
SMART SENSOR TECHNOLOGY
NRP
7
2
Figure 6-1: Setup with the web user interface
1 = Signal source
2 = LAN power sensor
3 = RJ-45 Ethernet connector
4, 6 = RJ-45 Ethernet cable
5 = Ethernet switch supporting PoE power delivery
7 = Computer with a supported web browser installed
Incorrectly connecting/disconnecting the R&S NRP power sensors can
damage the power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensor as described in
Chapter 4, "Preparing for Use", on page 10.
Starting a measurement
1. Connect the cables as shown in Figure 6-1.
For a detailed description, refer to Chapter 4.6.3, "Using a LAN Connection",
on page 18.
2. Open a supported web browser.
Browser-Based User Interface
To Next Page
Loading...
