Instrument tour
R&S
®
SMA100B
37Getting Started 1419.8620.02 ─ 10
The PC 1.85 mm male connector for up to 67 GHz comes with a protective
1.85 mm female adapter to prevent the sensitive connector from damage.
It is available as a spare part, and can be replaced if damaged. Contact your
Rohde & Schwarz support center or www.rohde-schwarz.com/support for
information.
How to: Chapter 4.10, "Connecting to RF 50 Ω", on page 26
5.1.12 Pulse signal connectors
Pulse Sync
BNC connector for output of a signal to synchronize the pulse generator signal.
The synchronization signal is generated at the beginning of each pulse. For dou-
ble-pulse generation, the synchronization signal is generated at the beginning of
the first pulse.
Pulse Video
BNC connector for output of the internal pulse generator signal or the looped
through pulse signal from Pulse Ext connector (video signal).
Pulse Ext
BNC connector for input of an external pulse modulation signal or an external trig-
ger/gate signal for the pulse generator.
5.1.13 LF modulation connectors
LF
BNC connector for output of the internal LF generator signal.
See the data sheet and in the user manual, section "Analog modulation".
Ext
BNC connector for input of external analog modulation signals.
Front panel tour
To Next Page
Loading...
