Rohde & Schwarz SMB100A - Connecting to Power; Connecting to LAN

Preparing for Use
R&S
®
SMB100A
18Quick Start Guide 1407.0812.62 ─ 20
4.6 Connecting to Power
For safety information, see "Connecting to power" on page 8.
If there were any problems duirng power on, check the condition of the mains fuses as
described under "Maintenance, Storage and Disposal > Changing Fuses" in the oper-
ating manual.
To connect the R&S SMB to power:
1. Plug the AC power cable into the AC power connector at the rear panel of the
instrument. Only use the AC power cable delivered with the R&S SMB.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
4.7 Connecting to LAN
Network environment
Before connecting the product to a local area network (LAN), consider the following:
●
Install the latest firmware to reduce security risks.
●
For internet or remote access, use secured connections if applicable.
●
Ensure that the network settings comply with the security policies of your company.
Contact your local system administrator or IT department before connecting your
product to your company LAN.
●
When connected to the LAN, the product may potentially be accessed from the
internet, which may be a security risk. For example, attackers might misuse or
damage the product.
To connect to LAN
The "LAN" connector is at the rear panel.
► Connect the LAN socket with an RJ-45 cable to the LAN.
By default, the R&S SMB is configured to use DHCP (dynamic host configuration pro-
tocol) and no static IP address is configured.
If switched on and connected to the LAN, you can find the address information in the
network settings dialog.
See "Instrument Function > General Instrument Settings > General Configuration of
Instrument - Setup Key > Network Settings" in the operating manual.
Connecting to LAN