Preparing for Use
R&S
®
SMB100A
32Quick Start Guide 1407.0812.62 ─ 20
2. Enter the following address:
vnc://<IP-address of the instrument>, e.g. vnc://192.168.1.1.
A dialog is opened and the password for the remote VNC connection is requested.
3. Enter the password as defined in the "Default Local System Properties" panel of
the Ultr@VNC program and select "Log On".
The connection is established, the instrument is remote accessed and the current
signal generator screen with the block diagram is displayed. The individual func-
tions are operated using the mouse and keyboard.
In contrast to remote access via Remote Desktop, the direct control of the instru-
ment is not disabled and the instrument can be controlled from the front panel and
via the remote computer alternately.
Setting up the VNC connection on the Windows remote computer
1. Start VNC Viewer program component on the PC, select "VNC Server" and enter
IP address of the instrument.
2. To initialize the connection, select "Connect".
A message requesting the password appears.
3. Enter the password as defined in the "Default Local System Properties" panel of
the Ultr@VNC program and select "Log On".
The connection is established, the instrument is remote accessed and the current
signal generator screen with the block diagram is displayed. The individual func-
tions are operated using the mouse and keyboard.
Enabled Direct Control
The direct control of the instrument is not disabled and the instrument can be control-
led from the front panel and via the remote computer alternately.
Remote Access via an External Controller
To Next Page
Loading...
