Instrument Control
R&S
®
SMB100A
63Quick Start Guide 1407.0812.62 ─ 20
Key of PC keyboard Short description Function
ALT + F12 Enter function
Unit dBm
Confirms entries in the base unit and val-
ues without a unit.
Selects dBm for the RF level and dB for
level offset and level step width.
Arrow keys Cursor Moves the cursor.
Backspace Clears entry Clears the last entry (number, sign or deci-
mal point)
CTRL + A Rearrange Arranges open dialogs automatically
CTRL + C Recalculate Starts recalculation of the signal.
CTRL+ D Block diagram Sets the cursor on the block diagram and
hides all menus.
CTRL + E Setup menu Opens the setup menu for general instru-
ment settings.
CTRL + F1 – F8 Softkey 1 – 8 Triggers the function assigned to the soft-
key.
CTRL+ F Frequency Activates the frequency entry.
CTRL + G Closes menus Closes an active menu.
CTRL+ H Hide Minimizes the active menu. Pressing the
respective button in the Winbar opens the
menu again.
CTRL + I Info Opens/closes the info window
CTRL + L Level Activates the level entry.
CTRL + M Menu Calls the menu selection list.
CTRL + O Modulation on/off Switches modulation on/off. "MOD OFF" is
indicated in the status line.
CTRL + P Preset Restores a defined basic instrument setup.
CTRL + Q Local Switches the instrument from remote con-
trol to manual control.
CTRL + R RF on/off Switches the RF output signal on/off. "RF
OFF" is indicated in the status line. Both
RF output signals are always deactivated
in the case of two-path instruments.
CTRL + S Storage under Windows Activates the menu for storing instrument
settings.
CTRL + T Toggle on/off Switches a block or parameter on/off.
Toggles between the different possibilities
of setting a selection parameter.
CTRL+ Y Hardcopy Opens the menu for configuring and start-
ing a hardcopy.
CTRL + W Winbar Displays the Winbar in the foreground/
background.
Enter Enter Terminates an entry.
Manual Operation
To Next Page
Loading...
