Instrument Control
R&S
®
SMB100A
76Quick Start Guide 1407.0812.62 ─ 20
2. Press a numeric key to activate the editing mode.
The previous value is cleared and the new value can be entered.
Editing a value in the insert mode (default setting)
1. Press the rotary knob (= Enter) to activate the editing mode.
If the cursor is placed at the right of the total value, the insert mode is always
active.
2. Set the cursor to the left of the number to be changed using the [Left/Right] arrow
keys.
The cursor is displayed in green.
3. Click on a numeric key to insert a new value.
Editing a value in the overwrite mode
1. Activate the editing mode.
2. Set the cursor on the numeric digit to be changed using the [Left/Right] arrow keys.
The cursor is displayed in blue and the number to be replaced is highlighted.
3. Click on a numeric key to overwrite the highlighted value.
Varying a value
1. Activate the editing mode.
2. Set the cursor to the left of the number to be changed using the [Left/Right] arrow
keys.
The value at the cursor position is varied.
3. To vary the selected value, use the [Up/Down] arrow key or turn the rotary knob.
The value is increased or decreased.
Entering a new alphanumerical value
1. Select the parameter.
2. Press an alphanumeric key to start the editing mode.
The new value is entered.
Editing an alphanumerical value
An existing value, e.g. a file name, can be changed in the insert mode (see example)
or in the overwrite mode.
1. Select the paramter and activate the editing mode.
Manual Operation
To Next Page
Loading...
