Instrument Control
R&S
®
SMB100A
78Quick Start Guide 1407.0812.62 ─ 20
The new unit is indicated in the value field of the menu.
8.1.5.6 Selecting a Value from a List
Selection lists provide a list of predefined values for the selected parameter.
To select a item from a list, proceed as follow:
1. Press [ENTER] key to open the list.
2. Use one of the following alternatives to navigate through the list:
a) Turn the rotary knob or use the [Up/Down] arrow keys.
The selected item is highlighted.
b) Press [TOGGLE ON/OFF] key several times until the preferred entry is dis-
played in the selection field.
3. To confirm the selection, press the [ENTER] key.
8.1.5.7 Terminating Entries with Confirmation
The instrument behaves different by the termination of entries deppending on the
parameter type and the way this parameter is set.
Confirming settings
► To confirm the settings, press the rotary knob or one of the [Unit] keys (see also
Chapter 8.1.5.5, "Working with Units", on page 77) .
Note: Variations by means of the rotary knob are immediately set.
Confirming multiple values
In some cases, like for instance when editing data in a user correction table, it is useful
first to enter few values and to confirm them together. Such settings require additional
confirmation. Not yet confirmed settings are displayed on a yellow background as an
indication that the currently displayed values do not represent the target signal.
► To confirm these settings, select the "Save" or "Accept" button, respectively.
Manual Operation
To Next Page
Loading...
