Rohde & Schwarz XT 4410A - Menu 580: MARKER CONTROL

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Special Conditions
– 3.16 – 6076.0822.12.01
Starting point: Menu 040 (MAIN)
1. Press softkey
Menu 400 (RADIO MAINTENANCE)
2. ENTER maintenance PIN by using
the numerical keypad, then press
ENTER.
3. Press softkeys
Menu 565 (DEVICE MAPPING)
4. Select CIPHER UNIT by using the
tuning knob.
5. Press softkey
6. Select Comline 1 by using the tuning
knob, then press ENTER.
7. Press softkey
8. Select KY58BB or KY58DP by using
the tuning knob, then press ENTER.
9. Press softkey
10. Press key (front panel).
11. Press key again.
12. Enter maintenance PIN by using the
numerical keypad, then press
ENTER.
13. Press softkeys
Menu 560 (AUDIO MAPPING)
14. Check if audio lines NB1 and WB1
are connected with Comline CL1. If
necessary, connect.
15. Press softkey
Menu 550 (PTT COMLINE MAPPING)
16. Check if keyline PTT_1L is connected
with Comline CL1, if it is low-active
and only effective in remote mode. If
necessary, configure.
17. Press softkey
Menu 570 (SQUELCH POLARITY)
18. Select squelch SQ COMLINE 1 by us-
ing the tuning knob.
19. Press softkey to set the
squelch level to low.
20. Press softkeys
Menu 575
(FRONTPANEL AUDIO SOURCE)
21. Select audio source 1 by using the
tuning knob.
22. Press softkey
23. Select source CL1 by using the tuning
knob.
24. Press softkeys
Menu 580 (MARKER CONTROL)
25. Press softkey to enable
plain marker tone.
26. Press softkey
Menu 510 (RADIO MODULES)
27. Press softkey
28. Select module audio interface by us-
ing the tuning knob.
29. Press softkey