Rohde & Schwarz XT 4410A - Malfunction; Visual Inspection Procedures

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Malfunction
6076.0822.12.01 – 4.1 –
 0DOIXQFWLRQ
 ,QWURGXFWLRQ
This chapter provides information concerning
q Visual Inspection
q Troubleshooting
- BIT Design
- BIT Radio (Menu RADIO MAINTENANCE)
- BIT Control Unit (Menu CU MAINTENANCE)
 9LVXDO,QVSHFWLRQ
Check the following:
1. Check external cabling between the complete transceiver and external equipment.
2. Check all connectors for firm seating and the power supply cable and RF coaxial cables
at the rear for mechanical damage. If necessary, replace cables by new ones one at a
time until the defective connection has been found.
&$87,21
,IDFRQQHFWRUVKRZVDQ\GLVFRORXUDWLRQFDXVHGE\KHDWLWVPDWLQJFRQQHFWRULVDOVR
GHIHFWLYHDQGPXVWEHUHSODFHGWRR
Obvious damage of minor importance can be eliminated on the spot, provided that the appro-
priate equipment is available. In case of severe damage, the transceiver must be sent to the
nearest repair facility.