Rohde & Schwarz XT 4410A - Menu 800: CU MAINTENANCE

065 75$16&(,9(5  ; 0  ; 0
Operator’s Manual • Use under Special Conditions
– 3.72 – 6076.0851.12.02
 0HQX&8,19(1725<
This menu gives an overview of the hardware, software and firmware components installed in
the control unit.
Starting point: Menu 800 (CU MAINTENANCE)
+ Press softkey (4) and the following display appears:
softkey INVENTORY...
0HQX
Types:
SW - identifier for software
FW - identifier for firmware
HWM - identifier for hardware module
HW - identifier for hardware
see Appendix A1