Rohde & Schwarz XT 4410A - Page 132

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Special Conditions
– 3.18 – 6076.0822.12.01
56. Press softkeys
57. Select module VU RX (receiver) by
using the tuning knob.
58. Press softkey
Menu 515 (VU RX PARAMETERS)
59. Press softkey
60. Select a new AF AGC ATTACK time
by using the tuning knob, then press
ENTER.
61. Press softkey
62. Select a new AF AGC DECAY time by
using the tuning knob, then press
ENTER.
63. Press softkey
64. Enter a new threshold by using the
numerical keypad, then press
ENTER.
Range: 6 dB to 20 dB
65. Press softkey
66. Select a new clipper level by using the
tuning knob, then press ENTER.
67. Press softkey
68. Select module VU SYN (synthesizer)
by using the tuning knob.
69. Press softkey
Menu 517 (VU SYN PARAMETERS)
70. Press softkey
71. Enter a new value for TX Deviation
(FM, narrowband) by using the nu-
merical keypad, then press ENTER.
Range: 1 kHz to 20 kHz;
3.5 kHz recommended