Rohde & Schwarz XT 4410A - Page 246

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Technical Information
– A1.20 – 6076.0822.12.01
Starting point: Menu 040 (MAIN)
1. Press softkey
Menu 400 (RADIO MAINTENANCE)
2. ENTER maintenance PIN by using
the numerical keypad, then press
ENTER.
3. Press softkeys
Menu 510 (RADIO MODULES)
4. Press softkey
5. Select module VU POWER
AMPLIFIER by using the tuning knob.
6. Press softkey
Menu 516 (VU TX PARAMETERS)
7. Press softkey
8. Select UHF Agile Filter FD 430 by us-
ing the tuning knob, then press
ENTER.
9. Press softkey
10. Select UHF Agile Filter FD 430 by us-
ing the tuning knob, then press
ENTER.
11. Press softkey
12. Select power level LOW by using the
tuning knob, then press ENTER.
13. Press softkey
14. Enter a new power level by using the
numerical keypad, then press
ENTER.
15. Press softkey
16. Enter a new power level by using the
numerical keypad, then press
ENTER.
17. Press softkey
18. Select power level MED by using the
tuning knob, then press ENTER.
19. Press softkey
20. Enter a new power level by using the
numerical keypad, then press
ENTER.
21. Press softkey
22. Enter a new power level by using the
numerical keypad, then press
ENTER.
23. Press softkey
24. Select power level HIGH by using the
tuning knob, then press ENTER.
25. Press softkey
26. Enter a new power level by using the
numerical keypad, then press
ENTER.
27. Press softkey
28. Enter a new power level by using the
numerical keypad, then press EN-
TER.