Rohde & Schwarz XT 4410A - Default Settings

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Technical Information
– A1.22 – 6076.0822.12.01
$ 'HIDXOW6HWWLQJV
There are two different scenarios for default settings to become active:
q The radio is powered up for the first time.
q The radio is reset during operation by using softkey DEFAULT SETTINGS in Menu 400.
In this case only the maintenance parameters will be reset, all other parameters are not
affected. In the tables below, such parameters non-affected by a reset are marked by an
"N" in the last column.
Frequency 310 MHz (UHF and VHF/UHF)
Mode FIX.FRQ
Guard OFF
Power HIGH
Modulation AM
Squelch ON
Marker OFF
H-Duplex
H-Duplex RX
H-Duplex TX
OFF
310 MHz (UHF and VHF/UHF)
311 MHz (UHF and VHF/UHF)
Clipper OFF
COMM V/D UNCPH
Chan SP 25 kHz
Tx Offs OFF
AF AGC OFF
Preset No. 0
Band UHF
Radio Time
Date
00:00
01.01.70
N
N
Default Address Radio Logical 46
IP 192.168.052.046 T R
N
Radio Modules Slot 0 VU GRX, ALL
Slot 3 VU SYN, CL1
Slot 4 VU RX, CL1
Slot 17 VU TX, CL1
Slot 18 PLAT, ALL
Slot 19 AFI, CL1
Slot 20 PLAT INT, ALL
N
N
N
N
N
N
N
Operation type Manual
Remote Control RS485 (X24) 9 600, 7, 1, ODD, RS485, S400U protocol