065 75$16&(,9(5 ; $ ; $
Operator’s Manual • LAN / V.24 Remote Control (GB2PP Protocol)
– A3.2 – 6076.0822.12.01
$ 6HFRQGDU\&RPPDQGV
AC Set and request the current communication mode of the radio
AD Define and request the current address definition list of the radio
AF Set and request the configuration parameters of the AFI
AG Set and request the current AF AGC status
AM Set and request the audio mapping between audio and Comline
AP Set and request the active control port
AS Set and request the order of audio output at the radio front panel
AS Start / stop scan mode
AT Set all trap-commands to off
CC Request the current capabilities of the Comlines
CD Request the detail of one entry in the CBIT list
CL Clear the complete error list of the radio
CL Set and request the clipper status for the receiver module
CO Set and request the current communication mode
CP Change stored PIN number
CP Set and request the current parameter page
CS Request the status of the last CBIT
CS Request and trap the current cipher unit status
DM Request the current data port mode status
DM Set and request the device mapping between an external device and the radio
DM Set and request the default communication mode of the radio
DO Delete an activated radio option
DP Disable activated user PIN
DP Delete one or a range of Preset Pages
DS Set all radio settings to default values
DS Set and request the default Tx power switch
ED Request the error detail for an error log entry
EE Request the data of one error log entry
EL Request the error list with all error log entries
EP Enable special PIN for a user
ET Request the current radio elapsed time
FD Set and request the mapping for full duplex mode
GN Request the current GO/NOGO status of the radio
GR Set and request the current guard receiver status
ID Request the detail of one entry in the IBIT list
IL Request the inventory list of the radio
IR Enable / disable Rx
IS Request the status of the last IBIT
IT Enable / disable Tx
LD Set and request the logical address of a local control unit
LI Set and request the LAN interface parameters
LP Set and request the parameters of one preset page within the loaded preset
LS Request a status list of the preset pages stored in the loaded preset
To Next Page
Loading...
