Rohde & Schwarz ZNB - Page 1074

Command Reference
R&S
®
ZNB/ZNBT
1074User Manual 1173.9163.02 ─ 54
Connector and calibration kit names must be entered as string parameters. The strings
contain the connector and cal kit names used in the Calibration Kits dialog; a Ω
in the name must be replaced by 'Ohm', e.g.:
–'NewKit1' denotes the user-defined calibration kit "NewKit1".
–'N 50 Ohm Ideal Kit' denotes the "N 50 Ω Ideal Kit".
–'ZV-Z21 typical' denotes the cal kit "ZV-Z21 typical".
MMEMory:LOAD:CKIT:UDIRectory <Directory>
Specifies the "Search Path for Additional Cal Kits and Connector Types". All cal kit files
in the specified directory will be (re-)loaded automatically as predefined kits (i.e. read-
only kits which cannot be modified) every time the VNA application is started.
Parameters:
<Directory> String parameter to specify the directory path. The directory can
be created separately (MMEMory:MDIRectory). An empty
string means that no cal kit files will be loaded.
Example:
MMEM:LOAD:CKIT:UDIR 'C:\Users\Public\Documents
\Rohde-Schwarz\Vna\Calibration\Kits\Autoload'
Specifiy the directory for additionally available cal kits.
MMEM:MDIR 'C:\Users\Public\Documents
\Rohde-Schwarz\Vna\Calibration\Kits\Autoload'
Create the specified "Autoload" directory.
MMEM:STOR:CKIT 'New Kit 1', 'C:
\Users\Public\Documents
\Rohde-Schwarz\Vna\Calibration\Kits\Autoload
\New Kit 1.calkit'
Store the data for the existing, user-defined cal kit "New Kit 1" to
the "Autoload" directory.
Manual operation:
See "Search Path for additional Cal Kits and Connector Types"
on page 703
MMEMory:LOAD:CMAP <ColorSchemeFile>
Loads a color scheme from a specified VNA color scheme file.
Setting parameters:
<ColorSchemeFile> String parameter to specify the name and directory of the color
scheme file to be loaded. The default extension (manual control)
for color scheme files is *.ColorScheme, although other exten-
sions are allowed.
SCPI Command Reference