Rohde & Schwarz ZNB - Page 869

Command Reference
R&S
®
ZNB/ZNBT
869User Manual 1173.9163.02 ─ 54
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<HorizontalPos> LEFT | MID | RIGHt
Horizontal position
<VerticalPos> TOP | MID | BOTTom
Vertical position
Example: See CALCulate<Chn>:LIMit:FAIL?
Manual operation: See "Limit Check" on page 344
CALCulate<Chn>:LIMit:TTLout<Pt>[:STATe] <Boolean>
Switches the TTL pass/fail signals on or off. The signals are applied to the USER
PORT as long as the active trace <Chn> is within limits, including the ripple limits.
See Chapter 11.3.1.1, "USER PORT", on page 1427.
Default values for new traces can be set using SYSTem:TTLout<Pt>:STATus[:
STATe].
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Pt> 1 - TTL out pass 1 (pin 13 of USER PORT connector)
2 - TTL out pass 2 (pin 14 of USER PORT connector)
Parameters:
<Boolean> ON | OFF - TTL output signal on or off.
*RST: OFF
Example:
*RST; :CALC:LIM:CONT 1 GHZ, 2 GHZ
Define an upper limit line segment in the stimulus range
between 1 GHz and 2 GHz, using default response values.
CALC:LIM:STAT ON; TTL2 ON
Switch the limit check on and activate the TTL out pass 2 signal.
Manual operation: See "TTL1 Pass / TTL2 Pass" on page 346
8.3.1.12 CALCulate:MARKer...
The CALCulate:MARKer... commands control the marker functions. The com-
mands are device-specific and beyond what is specified in the SCPI subsystem
SOURce:MARKer....
CALCulate:MARKer:COUPled[:STATe]............................................................................. 870
CALCulate:MARKer:COUPled:TYPE................................................................................871
CALCulate:MARKer:FUNCtion:BWIDth:GMCenter............................................................ 871
CALCulate<Chn>:MARKer[:STATe]:AREA........................................................................ 872
CALCulate<Chn>:MARKer:DEFault:FORMat....................................................................872
CALCulate<Chn>:MARKer:MPEak:EXCursion.................................................................. 873
SCPI Command Reference