GUI Reference
R&S
®
ZNB/ZNBT
618User Manual 1173.9163.02 ─ 54
1L Measurement/2L Measurement/3L Measurement
The settings in the "1L Measurement"/"2L Measurement"/"3L Measurement" sections
configure and control the measurement of the 1st/2nd/3rd line.
The "1L Measurement" is always enabled. Depending on the selected "Method"
on page 615, the "2L Measurement" and "3L Measurement" can be disabled.
Load File ← 1L Measurement/2L Measurement/3L Measurement
Loads coupon measurement results from a s2p or s4p Touchstone file.
Remote command:
CALCulate:FMODel:DELT<Ph_pt>:M1L:FILename
CALCulate:FMODel:DELT<Ph_pt>:M2L:FILename
CALCulate:FMODel:DELT<Ph_pt>:M3L:FILename
Measure ← 1L Measurement/2L Measurement/3L Measurement
Measures the full set of S-parameters at the selected ports (full 2- or 4-port).
Remote command:
CALCulate:FMODel:DELT<Ph_pt>:M1L:MEASure
CALCulate:FMODel:DELT<Ph_pt>:M2L:MEASure
CALCulate:FMODel:DELT<Ph_pt>:M3L:MEASure
Ports table ← 1L Measurement/2L Measurement/3L Measurement
Use the checkboxes in the "Active" column to include the respective port into the mea-
surement.
If Method 1L is used, four ports have to be selected in the "1L Measurement" section.
Remote command:
CALCulate:FMODel:DELT<Ph_pt>:M1L[:STATe]
CALCulate:FMODel:DELT<Ph_pt>:M2L[:STATe]
CALCulate:FMODel:DELT<Ph_pt>:M3L[:STATe]
Offset Embed Softtool
To Next Page
Loading...
