GUI Reference
R&S
®
ZNB/ZNBT
686User Manual 1173.9163.02 ─ 54
Remote command:
DISPlay[:WINDow<Wnd>][:STATe] ON
Delete Diagram
Deletes the current diagram area including all traces displayed in the diagram area.
The remaining diagrams are renumbered; each recall set always contains diagrams
with contiguous numbers. "Delete Diag Area" is disabled if the recall set contains only
one diagram area: In manual control, each recall set must contain at least one diagram
area with one channel and one trace.
Tip: To restore a diagram area that was unintentionally deleted, use the undo function-
ality.
Remote command:
DISPlay[:WINDow<Wnd>][:STATe] OFF
Maximize Diagram
Maximizes the active diagram or restores the previous diagram arrangement.
For other split types, use the functions in the Split Tab.
Remote command:
DISPlay[:WINDow<Wnd>]:MAXimize
Title
Defines a title for the Active Diagram.
The visibility of the title area can be toggled using Show Title.
Remote command:
DISPlay[:WINDow<Wnd>]:TITLe:DATA
Via remote control, it is also possible to define a diagram name, and to retrieve the
lists of diagrams together with their names:
DISPlay[:WINDow<Wnd>]:NAME
DISPlay[:WINDow<Wnd>]:CATalog?
Show Title
Displays or hides the title area of the active diagram.
This property can only be set if Title is non-empty. If "Title" is empty, the title area is
always hidden
Remote command:
DISPlay[:WINDow<Wnd>]:TITLe[:STATe]
Display Softtool
To Next Page
Loading...
