ROHO PRODIGY - Placing the Overlay; General Placement Instructions; Straps for PRODIGY and SOFFLEX 2

5
ROHO Non-powered Mattress Overlays and Accessories Operation Manual
3) Place the overlay sections on the bed mattress, cells facing up.
4) Align the overlay sections and snap them together.
-If you are using Insert Pads or Leveling Pads: Refer to the instructions in this manual for attachment.
-If you are using Bariatric Overlay sections: Align and attach the Bariatric sections to the Standard Overlay sections, as
prescribed.
5) PRODIGY and SOFFLEX 2 must be secured to the bed mattress. If you are not using the Overlay Enclosure Cover, follow the
instructions below to use the straps provided with PRODIGY and SOFFLEX 2.
6) Continue with the instructions provided in this manual for inflating, covering and adjusting the overlay.
Warnings:
- Risk of falling. The PRODIGY and SOFFLEX 2 overlays MUST be secured to the bed mattress, either with the provided straps or
with the Overlay Enclosure Cover straps.
- Risk of falling: Any overlay section or system MUST NOT hang over the edges of the bed mattress.
Align and snap the sections together.
The Standard Overlay on a bed mattress, shown without a cover.
Note: If you are using the Overlay Enclosure Cover, you will not use
these straps. See the instructions for the Overlay Enclosure Cover in
this manual.
1) Use a strap on each corner of the PRODIGY or SOFFLEX 2 Overlay
System. Attach both ends of the strap to the snaps on the
overlay, as shown.
2) Stretch a strap around each corner of the bed mattress.
3) Continue with the instructions for inflating the overlay in this
manual.
Attach the straps, and then stretch a strap around each corner
of the bed mattress.
Straps for PRODIGY and SOFFLEX 2
Warnings:
- Risk of falling. The PRODIGY and SOFFLEX 2 overlays MUST be securely attached to the bed mattress.
- Before the individual transfers onto the overlay, make sure the straps are securely snapped to the overlay.
STOP HERE if you are using the two-piece, zipped Overlay Enclosure Cover. See the instructions for the Overlay Enclosure Cover provided
in this manual. If you are NOT using the Overlay Enclosure Cover, continue with the instructions on this page.
1) Remove all bed linens from the bed mattress. A support pad or a fitted sheet may remain on the bed mattress.
2) Make sure the bed mattress is in a flat position.
Placing the Overlay
General Placement Instructions