ROHO PRODIGY - Insert Pad and Leveling Pad; Overlay Enclosure Cover

To Next Page

To Previous Page

ROHO Non-powered Mattress Overlays and Accessories Operation Manual

Leveling Pad Placement

1) Place the Standard Overlay into the open area of the Leveling

Pad as prescribed.

2) Continue with "Inflating the Overlay" in this manual.

Insert Pad Placement

1) Align and attach Insert Pad section(s) to Standard Overlay

sections as prescribed.

2) Continue with the "Inflating the Overlay" instructions in this

manual.

Align and attach the Insert

Pad section(s) to the

Standard Overlay sections.

Leveling Pad

Insert Pad

Warnings:

- If an individual is at risk of skin/soft tissue breakdown, DO NOT use Insert Pads or Leveling Pads to replace overlay sections.

- At the first indication of tissue trauma, Insert Pads or Leveling Pads MUST be replaced with Standard Overlay section(s).

- Make sure that the Leveling Pad(s) and Standard Overlay Sections(s) are snapped together when the individual is on the

product. If the sections are not snapped together, the individual could be exposed to areas that do not provide sufficient skin

protection.

1) Place the Overlay Enclosure Cover on the bed mattress. Refer to the labels on the cover for correct orientation.

2) Unzip and remove or fold back the top part of the cover.

3) Place the overlay sections onto the bottom part of the Overlay Enclosure Cover, cells facing up.

4) Align the overlay sections and snap them together. If you are using Insert Pads or Leveling Pads, refer to the instructions in this

manual for attachment.

5) For the Standard Overlay: There are two inflation valves for each overlay section. Close all valves on one side of the overlay.

6) Place the top part of the cover over the overlay. Leave the cover at least partially open. You will need to access the inflation valves on

one side of the cover. Note: Do not zip the Overlay Enclosure

Cover closed until adjustment is complete.

7) Wrap the straps under the bed mattress and secure the

buckles.

8) Follow the instructions in this manual to inflate and adjust

the overlay.

The Overlay Enclosure Cover is attached to the bed

mattress with the straps.

Overlay Enclosure Cover

Warning: Risk of falling: The PRODIGY and SOFFLEX 2 overlays MUST be secured to the bed mattress, either with the

provided straps or with the straps on the Overlay Enclosure Cover.

Insert Pad and Leveling Pad

Placing the Overlay, Continued

Open