7
ROHO Non-powered Mattress Overlays and Accessories Operation Manual
Warning: Placing too many linens between the individual and the product will reduce its the effectiveness.
To cover the overlay:
Before the individual transfers to the bed, cover the overlay. Follow these guidelines.
- Use no more than one flat or contoured sheet, arranged loosely over the mattress overlay.
- Use one incontinent pad, if needed.
- Use one draw sheet for moving and transferring, if needed.
ROHO Cover Options:
- One-piece Reusable Overlay Cover with elastic: Refer to the directional labels on the cover to orient and place the cover around the
overlay and the bed mattress.
- Two-piece, zipped Overlay Enclosure Cover with straps: See the instructions in this manual for the Overlay Enclosure Cover.
Cover Guide
Inflating the Overlay
Notes:
- If an overlay section has more than one valve, only one of the valves
should be open during inflation.
- The PRODIGY and SOFFLEX 2 inflation valves are located on the
bottom of each section.
1) Slide the rubber nozzle of the hand pump over the inflation valve.
2) Pinch the nozzle of the hand pump, and open the inflation valve.
3) Add air until all of the air cells are inflated and the overlay section
arches slightly.
4) Pinch the nozzle of the hand pump, and close the inflation valve
completely.
5) Remove the hand pump.
6)
IMPORTANT! Follow the instructions to adjust the overlay.
Inflate all of the overlay sections until they arch slightly.
Warning: All sections of the product, including any bariatric (side) sections, MUST be inflated and adjusted to ensure proper
immersion and to provide skin/soft tissue protection to the individual, including their areas of risk (for example, head, shoulder
blades, tailbone, hip bones, heels).
Close
Open
Placing the Overlay, Continued
To Next Page
Loading...