16
“Please wipe the anti-fall sensor and start away from the dangerous area.”
• Please check if the appliance is suspended and move it to a new location to start.
• Please check whether the anti-fall sensor is too dirty or blocked by dust or other
debris. You need to wipe the anti-fall sensor regularly.
“Please check if the roller brush is stuck.”
• Please check whether the roller brush is entangled with wool, wires, and other
windings. Remove the roller brush and clean it.
• Please check whether there are any entangled objects such as wool and
wires/cords on the indoor floors and clean them up.
• The roller brush may tangle and needs to be cleaned regularly.
“Please check if the side brush is stuck.”
• Please check whether the side brush is entangled with wool, wires, or other
debris. If so, remove the roller brush and clean it.
• Please check whether there are any entangled objects such as wool or wires on
the indoor floor and clean it up.
• The side brush may tangle and needs to be cleaned regularly.
“Please check if the main wheel is stuck.”
• Please check whether there is any debris stuck on the wheels and remove them.
“Please put back the dust box.”
• Please put back the dust box, make sure the filter and dust box are installed in
place.
• If the error is still reported after the installation is in place, please try to replace
the filter.
“Low battery, please charge.”
• Low battery, please recharge before use.
“Recharge failed, please check whether the connection between the appliance and
the base station is normal.”
• Please use a dry cloth to wipe the charging contacts of the appliance and the
charging ports of the base station.
“The battery temperature is abnormal, please try again later.”
• The battery temperature is too high, or the temperature is too low, please wait
for the battery temperature to be normal before use.
“Please check the right wall sensor.”
• The wall sensor is blocked by dust, please wipe the wall sensor on the right.