18
“Please load the cleaning tray.”
• Please check whether the cleaning tray is in place or installed in place, and
reinstall the cleaning tray.
“The dust bag is not in place, please check if its installed.”
• Please check if the dust bag is installed.
• If the dust bag is installed, please check if the dust bag is inserted all the way.
“The base station wind pressure is abnormal.”
• Please check if the top cover of the base station is closed.
• Please check if the dust bag is full and replace it in time.
“The dust bag is full.”
• If the dust bag is not full, please check whether the dust channel of the base
station is blocked. If the dust channel of the base station is blocked, please try to
clean the dust channel manually.
“Abnormal dust collection.”
• Please check whether there is any wedged objects in the dust collection port of
the dust bag of the base station, please clean up the foreign matter in the dust
collection port.
• Please check if the dust box is blocked, please clean the dust box.
“Standby.”
• When returning to the base station while mopping the floor, the clean water tank
is not in place or enters standby without water.
• When the wastewater tank is not in place or the water is full when it returns to
the base station in the mopping state, it is not replaced and enters standby.
• When returning to the base station in the mopping state, the cleaning disk is not
in place and enters standby.
• When returning to the base station, the washing tank is full and enters standby.
Tip: Resetting the system can eliminate some abnormalities.
To Next Page
Loading...
