Roland Aerophone Pro - Sound Settings; Sound Structure Overview; System Settings Introduction

8
Settings Used on this Instrument
Indication (Parameter)
Value Explanation
Fingering Mode
Species the ngering mode.
For details on ngering in each mode, refer to “Fingering Chart” (p. 66).
Sax Sax ngering
Recorder
Recorder ngering
This uses standard recorder ngering, with the pitch range expanded by the table key.
With this ngering, the side keys are disabled so that the note does not change even if you
inadvertently press the left or right side key.
E-Wind
Electronic wind instrument ngering
The same “C D E F G A B C” ngering as a standard sax or recorder, with key combinations that
raise/lower the pitch by a semitone.
1, 2, 3, 4, 5, 6, C The same “C D E F G A B C” ngering as a standard sax or recorder
Tc, G#, C# Raise by a semitone
Ta, Tf, Eb, B Lower by a semitone
Bb Lower by a whole tone
Trumpet
Trumpet ngering
This mode is close to the ngering of a typical brass instrument. Right-hand keys 4, 5, and 6
correspond to pistons 1, 2, and 3 of a trumpet.
Left Hand Fingering that lets you perform using only the left hand
Right Hand Fingering that lets you perform using only the right hand
Flute
Flute ngering
This uses standard ute ngering, with the pitch range expanded by the below keys.
x, C1, C2, C3 Raise by a semitone
p, B, C4, Tc, Ta Lower by a semitone
Bb Lower by a whole tone
Clarinet
Clarinet ngering
This uses standard clarinet ngering, with the pitch range expanded by the below keys.
C1 Raise by a semitone
p, C5 Lower by a semitone
User Fingering
You can add, edit, or delete your preferred ngerings.
* Up to 36 ngering settings can be specied.
* In this mode, transpose and octave shift settings are ignored.
For details on the displayed note name and ngering, refer to “Fingering Chart” (p. 66).
How to add or edit
1.
Select “User Fingering,” and then press the [MENU]
button.
2. Press a performance key.
The note name appears. If there is no corresponding
note, indicates “NONE.”
3. While ngering the desired key, press the octave
key [+2].
+2
4. Use the [C] [A] buttons to change the note name.
5. Press the [MENU] button.
A conrmation message appears.
6. To execute the write, press the [A] (YES) button.
If you decide to cancel the write, press the [C] (NO)
button.
An added or disabled ngering is indicated by a “*”
to the right side of the note name.
How to delete
1.
Select “User Fingering,” and then press the [MENU]
button.
2. Press a performance key.
The note name appears. An added or disabled
ngering is indicated by a “*” in the screen.
3. While ngering the desired key, press the octave
key [+2].
4. Use the [C] [A] buttons to choose “Del.”
5. Press the [MENU] button.
A conrmation message appears.
6. To execute the write, press the [A] (YES) button.
The “*” in the screen disappears.
If you decide to cancel the write, press the [C] (NO)
button.