27
Connecting Peripheral Devices
Quick Start
* When using the FS-5U foot switch (sold separately), set the
polarity switch as shown below. If the polarity switch is not set
correctly, the foot switch may not operate properly.
fig.00-304
* You can also use an FS-6 (optional) for the foot switch. If
using an FS-6, connect to only one of the FS-6's jacks, either
the A or B jack. Additionally, set the polarity switch to “FS-
5U.” The A&B jack cannot be used.
* If using an expression pedal (EV-5 or FV-300L), set the MIN
volume level to “0.”
Inserting a Memory Card
Insert the memory card (CompactFlash) with the gold-
colored contacts facing downward (the side without contacts
should be facing upward).
* Carefully insert the memory card all the way in-until it is
firmly in place.
* Do not touch the contacts of the memory card or allow them to
become dirty.
fig.00-305
Before inserting the memory card, be sure to first turn off the
BR-900CD. If a memory card is inserted when the power is
turned on, the data in the memory card may be destroyed, or
the memory card may become unusable.
Polarity Switch
To Next Page
Loading...
