86
Using the Insert Effects
Saving Insert Effects Settings
(Write)
Follow the procedure below to enter a name (patch name) for
an effect that you’ve modified, and save it as a new effect
patch.
* You cannot save an effect patch during the recording or
playback of a song.
* If you do not need to change patch name, go to step 4.
1. At the Effect screen, press CURSOR [ ] to move the
cursor to “NAME,” and press [ENTER].
The Patch Name Setting screen appears.
fig.01-508d
2. Use [CURSOR] and the TIME/VALUE dial to enter the
patch name.
* Press [ENTER] to switch between uppercase and lowercase.
3. After you have completed entering the effect settings
and patch name as desired, press [EXIT] to return to the
Effect screen.
4. Press CURSOR [ ] [ ] to move the cursor to
“WRITE,” and press [ENTER].
fig.01-509d
5. Turn the TIME/VALUE dial to select the number to
which to write the new effect patch.
6. After you’ve selected the destination, press [ENTER].
After the save has been completed, you are returned to
the Effect screen.
* During updating, “Keep power on!” appears in the upper line
of the display, while the lower line shows what is being
processed.
To Next Page
Loading...
