Roland CM-500 - 6 Using the Display Menus

29
6 Using the Display Menus
This section describes the basic steps for using the display menus. Use this information together with "7 Display Menus Flowchart" on
the following page to make menu settings.
Use the and keys to move the blinking cursor (" ") and choose a setting.
Then use the and keys to change the value (or the selection) and enable the setting by pressing the key.
Then use the and keys to change the value and
enable the setting by pressing the key
Press the key to advance
to the next setting screen
AREA AXIS
REPLOT SUBMENU
Press the key to change to
the next menu
AREA LENGTH
MOVE <1.0m>
ENTER
Use the and keys to move the
blinking cursor (" ") and choose a setting
Select "AREA"
The value enclosed in angled brackets ("<>") is the current setting
The selection enclosed in angled brackets ("<>") is the current setting
MENU
Use the and keys to move the blinking cursor
(" ") and choose a setting
• To return to the menu selection screen from any of the menu value setting screens, press the key.
• To return to the previous screen without changing the numerical settings, pressing the
key
without pressing the
key.