Roland CX-500 - User Manual

Thank you very much for purchasing the CX-500/400/300.
• To ensure correct and safe usage with a full understanding of this product's
performance, please be sure to read through this manual completely and store
it in a safe location.
• Unauthorized copying or transferral, in whole or in part, of this manual is
prohibited.
• The contents of this operation manual and the specifications of this product
are subject to change without notice.
• The operation manual and the product have been prepared and tested as much
as possible. If you find any misprint or error, please inform us.
• Roland DG Corp. assumes no responsibility for any direct or indirect loss or
damage which may occur through use of this product, regardless of any failure
to perform on the part of this product.
• Roland DG Corp. assumes no responsibility for any direct or indirect loss or
damage which may occur with respect to any article made using this product.

Summary

Checking Supplied Items

Setup

Setting Up

Provides instructions for physically setting up the CX-500/400/300 unit.

Connection

Installing and Setting Up the Driver

Basic Operation

Loading the Material (Roll Material)

Step-by-step guide for loading roll material into the CX-500/400/300.

Installing a Blade

Instructions for installing a cutting blade into the CX-500/400/300.

Adjusting the Blade Force and Cutting Speed

How to adjust blade force and cutting speed for optimal results.

Setting the Origin Point

Procedure for setting the starting point (origin) for cutting operations.

Starting Cutting

Step-by-step guide to start the cutting process after setup.

When Cutting is Completed

Instructions for safely completing a cutting job and powering down.

Maintenance

Cleaning

Consumable Items

How to Replace the Separating Knife

If There Is a Problem

Self-test Operation Check

How to perform a self-test to verify machine operation.

What to do if...

Troubleshooting guide for common operational issues and error messages.

Error Messages

Lists and explains potential error messages displayed by the unit.

Specifications

Roland CX-500 Specifications

General

Type	Cutting Plotter
Resolution	0.025 mm
Maximum Cutting Speed	500 mm/s
Software Resolution	0.025 mm
Power Supply	AC 100 to 240 V ±10% 50/60 Hz
Operating Humidity	30% to 80% (non-condensing)
Blade Holder	Standard blade holder
Cutting Force	30-350 gf
Power Requirements	AC 100 to 240 V ±10% 50/60 Hz