Roland D-50 - Page 26

EDITING PERFORMANCE CONTROLLING FUNCTIONS
Step 1: Push the right Scroll Button.
DL tecestesk teeters be teketokea LPs sabe steoteste beste ete]
WHOLE SP C4 Bal 56 LE steeectetestecte teste teat
PATCH
EOIT exIT
eG |
Step 2: Select “Output Mode” with the
corresponding Selector Button.
Teiio detewisiotkidobdokadobk Patoh Edit Menu
¢P-Nane> (Cantrol>(Outrut> (Chases cMIDI>
EXIT
C4 CO CoO fo ba fo oo
<a oo
Step 3: Select the parameter to be edited with
the Selector Button and edit it with
the Joystick.
Tei chieeeeioiookdaomdck Cuteut Mode Edit
Mode Gi Rey 41 Rbalig@a Wol1Ge
EXIT
ML
Te CO 4 |
Total Volume
This sets the volume of both Tones from 0 to 100, and
therefore adjusts the volume difference between Patches,
Reverb Balance
This sets the volume balance of reverb and direct sounds
from 0 to 100.
100 The volume of the reverb sound=maximum, the volume
of the direct sound=0.
i)
9o
The volume of the reverb sound=0, the volume of the
direct sound=maximum,
Output
Mode
Reverb
Type
This selects one of the following four output modes. This selects one of the 32 reverb types.(See page 25.)
U.OUT Stereo reverd works on the mixed sound of Upper and
LOUT Lower Tones, and is sent out in stereo.
U.OUT The Mixture of Upper and Lower takes on stereo reverb, and
LOUT the direct sound is sent out separately for Upper and Lower,
Me OUT | cnty tho Unner Tone takes on reverb. Upper and Lower
POWcR men Tor ty.
L.OUT nes are sent out separately.
ne U.OUT Onty the Lower Tone takes on reverb. Upper and Lower
Tones are sent out separately.
rere L.OUT be ¥.
26