Roland D-50 - Page 47

EDITING
Step 1 By pushing the appropriate Selector Button, call the Tone Copy
Display.( With the aid of the Edit Map, take the following
procedure.)
To copy to the Upper Tone, call the Upper Tone Menu Display, then
push the far—right Selector Button.
To copy to the Lower Tone, call the Lower Tone Menu Display, then
push the far-right Selector Button.
The location where the source —Ja-11
Tone is copied to. aa Toru
Source Tone
Step 2 While actually playing the keyboard, select the Tone to be copied
(Source Tone), and it will be copied to the Tone of the currently
selected Patch.
Select either the Upper or the Lower Tone. (Holding
the button down will change Patch numbers at the
same time.
)
ss mes pat ewe eve
S So] Sess
cS =} ——
SBS Ss Sess
SS S65 Baemamommm oesoaaaoo
Select a Patch number.
To select a Patch on the Memory Card, push the Card Button.
To select a Patch in the internal memory, push the internal Button.
At this stage changing the Display will show the Tone Name just
copied.
@Block Copy
A group of Tone Parameters can be copied within a Patch.
Stept
Step2 Exit Button
Step2
Ot
7 ? 7 LO
Ror
15