Roland D-50 - Page 48

@Select the Tone to be copied.
LOWER: Lower Tone
UPPER: Upper Tone
16
EDITING
Step 1
Step 2
a Dora Frota
UPPER ALL
Push the Copy Button.
Push the relevant Selector Button first, and select a source Tone,
and the Block to be copied, then the destination Tone and its Block
using the Joystick or Increment and Decrement Buttons as shown
below @ - ©.
” €Enter/Exitd
UPPER ALL
a)
@Select the Block to be copied.
ALL:
COMMON :
PART—1:
PART-2:
Alt the Parameters
Common Parameters
Partial 1's Parameters
Partial 2's Parameters
Step 3
rs Co
®Select the location for the source Block.
If COMMON is selected in step @. select COMMON here, and if
PART-1 or PART—2 is selected, select the corresponding Block,
@Select the location for the source Tone.
LOWER: Lower Tone
UPPER: Upper Tone
@if either PART-1 or PART—2 is selected in step @,
any of the following Blocks can be selected.
ALL: All the Parameters
WG: WG Parameters
TWF: TVF Parameters
TVA: TVA Parameters
To cancel the copying mode, simply push the Exit Button.
Hit the Enter Key.
When the copy is completed, the Display responds as shown below,
then returns to the Play Mode indication.
Complete .
*If you try to copy @ Common parameter to a Partial parameter or vice
versa, the Display will show the following error message and the
copying cannot be done.
Data Mismatch
Cancel ...