Roland D-50 - Page 58

TONE PARAMETERS
-d. LFO
{Display 21-23]
T-ii Ur diakekaobstokacto LFO-i Edit .
laveTRI Rate B86 Dely BG SunckKEY .
Wavefrom Rate Delay Time Syne
The parameters of LFO—2 (Display 22) and LFO~3 (Display 23) can
be set like LFO—1, except for a few parameters.
@ Waveform
This selects the waveform of the LFO.
Waveform changes randomly.
@ Rote
This sets the rate (frequency) of the LFO from 0 to 100. Higher
values quicken the rate.
@Delay Time
This sets the time needed for the LFO to appear, from the moment
a key is pressed. 0 to 100 are valid. Higher values increase the
delay time.
@ Sync
This selects the timing of the LFO oscillation as follows.
LFO does not sync to the keyboard.
When a key is played after all keys have been released, the
*For LFO-2 and LFO—3, “KEY”cannot be- selected.
LFO begins its wave generating process form the beginning.
LFO begins its wave generation form the beginning
each time a new key is played.
26