Roland D-50 - Page 93

Mi!
step 5 Set the transmitter to the signal—sending mode.
@ Handshake Mode
Select “B. Dump” with the corresponding Selector Button.
t+ Data Transfer * Select Ture ...
CB. Cunpo¢6. Load) CInteCrd) (CrdsInto
fe Data - Transfer + [ Bulk Qumr J
Are you sure 7 2... (EntberExit>
@ One-way Mode
While holding the Data Transfer Button down, push the Selector Button
that corresponds to “B. Dump’.
DATA
Co + + Data Transfer * Select Ture
4 CB. Dumped ¢B. Loads (InteCrdd <CrdsInt3
H+ Data Transfer +
Are wou sure
63