Connections and Settings
19
Recording
You can use your DAW software to record audio from the INPUT 1 jack and INPUT 2 jack. When a
device is connected to the INPUT 1 jack or to the INPUT 2 jack, set the [PHANTOM] switch (p. 9) and
the [INST] switch (p. 9) accordingly.
Example
When a guitar is connected to the INPUT 1 jack, set the
[INST] switch to “Hi-Z.”
When a condenser microphone is connected to the
INPUT 2 jack, set the [PHANTOM] switch to “+48V.”
Front panel Rear panel
Guitar Condenser microphone
Computer
* To prevent malfunction and equipment failure, always turn down the volume and turn o all
devices (except the computer) before making any connections.
* Acoustical feedback (howling) could be produced depending on the location of microphones
relative to speakers. This can be remedied by:
• Changing the orientation of the microphone(s).
• Relocating microphone(s) at a greater distance from speakers.
• Lowering volume levels.
Adjusting the Input Level
Use the [SENS 1] knob and the [SENS 2] knob to adjust the input
level so that the PEAK indicator does not light.
To Next Page
Loading...
