Roland F-110 - Producing Sounds from a MIDI Sound Module by Playing the F-110; Connecting a Computer

65
Connecting to Other Devices
fig.F-110MIDI2-e.eps_88
Making the Connection
1.
Turn the volume all the way down on the F-110 and
on the MIDI device you’re about to connect.
2.
Switch off the power to the F-110 and the MIDI
device you’re about to connect.
3.
Use MIDI cables (sold separately) to connect the
MIDI connectors to each other.
4.
Switch on the power to the F-110 and the
connected device.
5.
Adjust the volume level on the F-110 and the
connected device.
6.
You should also set the MIDI transmit channel as
needed (p. 58).
You can use a USB MIDI interface cable (sold separately) to
connect the F-110 to your computer.
If the F-110 is connected to a computer in which sequencer
software is installed, a song you’ve recorded on the F-110 can
be saved on your computer.
Connection Examples
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
power on all devices before making any connections.
* In order to make connections to your computer, you must
install “MIDI driver” software on your computer. For details,
refer to the owner’s manual for your MIDI interface.
Use a USB MIDI interface cable to connect the USB connector
of your computer to the MIDI connectors of the F-110.
fig.F-110comp.e.eps_88
Producing Sounds from a MIDI Sound
Module by Playing the F-110
MIDI Sound Module
MIDI Out
connector
MIDI cable
Connecting a Computer
USB MIDI Interface
Computer
USB Connector
of your Computer
MIDI Out/In
connectors
F-110_r_e.book 65 ページ ２００９年６月３０日 火曜日 午後１２時６分