Before You Play
Opening/Closing the Lid
You must use both hands to open or close the lid.
Opening the Lid
1. Use both hands to lift the edge of the lid, and push it away from
yourself.
Edge of lid
2. Push the lid away from yourself until it stops.
Closing the Lid
1. Grasp and gently lower the edge of the lid with both hands.
NOTE
• When opening or closing the lid, please be careful not to get your
ngers pinched between the movable part and the panel. In places
where small children are present, make sure that an adult provides
supervision and guidance.
• If you need to move the piano, make sure the lid is closed rst to
prevent accidents.
When opening or closing the lid, take care not to pinch
your ngers between the folding sections.
It is dangerous to close the lid by pressing it from above, since you risk
pinching your ngers between the sections of the lid.
Opening the lid by pushing it may cause this unit to fall over. You must
grasp the edge of the lid when opening or closing it.
Turning the Power On/O
Once everything is properly connected (p. 9), be sure to follow the
procedure below to turn on their power. If you turn on equipment in the
wrong order, you risk causing malfunction or equipment failure.
Turning the Power On
1. Turn the [L] switch ON.
After a brief interval, you’ll be able to produce sounds by playing the
keyboard.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after turning the unit on is required before it will operate
normally.
* Before turning the unit on/o, always be sure to turn the volume down.
Even with the volume turned down, you might hear some sound when
switching the unit on/o. However, this is normal and does not indicate
a malfunction.
2. Use the Volume buttons to adjust the volume.
The volume increases when you press the Volume [+] button, and
decreases when you press the Volume [-] button.
This will adjust the volume of the speakers if you’re using the speakers of
the unit, or the volume of the headphones if headphones are connected.
Each volume setting (for speaker or headphone) is saved automatically.
MEMO
The unit is designed so that nuances in the dynamics of your playing will
be clearly heard even at low volume, and that the sound will remain clear
even at high volume.
Turning the Power O
1. Turn the [L] switch OFF.
Setting the Reference Pitch
When playing ensemble with other instruments and in other such instances,
you can match the standard pitch to another instrument (Master Tuning).
1. In “Various Settings (Function Mode)” (p. 11), choose “
F07
”
and then press the [s] button.
2. Use the [-] [+] buttons to set the reference pitch.
Examples:
Reference pitch Display
440.0 Hz (default)
40.0
442.0 Hz
42.0
Press the [s] button to return to the previous screen.
3. If you want to save the setting, carry out the Memory Backup
procedure (p. 11).
4. Hold down the [Metronome] button and press the [Split] button
to exit Function mode.
10
To Next Page
Loading...
Need help?
General
