Roland Fantom-Xa - Transposing the Keyboard in Octave Units (Octave Shift); Transposing the Keyboard in Semitone Steps (Transpose); Selecting the Tones that will Sound (Tone On;Off)

33
Playing in Patch Mode
The Octave Shift function transposes the pitch of the keyboard in 1
octave units (-3– +3 octaves).
For playing a bass part more easily using your right hand, transpose
the keyboard down by 1 or 2 octaves.
* Octave Shift applies only to the keyboard part.
1.
In the PATCH PLAY screen, press OCTAVE [-] or [+] to set
the amount of transposition (-3– +3).
The button will light if this is set.
• Each time you press OCTAVE [+], the amount of transposition
will change in the order of +1, +2, and +3. Each time you press
OCTAVE [-], the amount of transposition will change in the
order of -1, -2, and -3.
• If you press both buttons simultaneously, the amount of
movement will be zero.
fig.OctaveShift
There is a single Octave Shift setting (Setup parameter) for the
entire Fantom-Xa. The changed setting will be remembered
even if you switch patches or performances.
Transpose changes keyboard pitch in units of semitones.
This function is useful when you play transposed instruments such
as trumpet or clarinet following a printed score.
* Transpose applies only to the keyboard part.
1.
In the PATCH PLAY screen, hold down [SHIFT] and press
OCTAVE [-] or [+] to adjust the Transpose setting (G–F#: -5–
+6 semitones).
• If you hold down [SHIFT] and press both buttons
simultaneously, the amount of movement will be zero.
fig.Transpose
There is a single Transpose setting (Setup parameter) for the
entire Fantom-Xa. The changed setting will be remembered
even if you switch patches or performances.
Since a patch is a combination of up to four tones, you can switch
unwanted (tones out of the four) off and get just the sound of a
specific tone.
• In the PATCH PLAY screen, press TONE SW [1]–[4] (PART/
TRACK [1]–[4]) to turn each tone on/off.
* If you want just one or two tones to sound in a patch, turn the others
off and store that setting on a patch. This cuts nonessential use of the
Fantom-Xa’s simultaneous voices.
Transposing the Keyboard
in Octave Units
(Octave Shift)
Transposing the Keyboard
in Semitone Steps
(Transpose)
Selecting the Tones That Will
Sound (Tone On/Off)
Fantom-Xa_e.book 33 ページ ２００４年１０月２２日 金曜日 午後２時３分