96
Playing Rhythms
1.
Hold down [SHIFT] and press [RHYTHM].
2.
Press [F2 (RHYTHM)].
The RHYTHM PATTERN screen appears.
fig.RhyPtn
3.
Press to select the parameter.
4.
Use the VALUE dial or [INC] [DEC] to make the setting.
* You can audition the rhythm pattern by pressing [F4 (PREVU)] to add a check mark (
✔
).
5.
When you have made the setting, press [EXIT].
Rhythm Pattern Settings
Parameter
Value Explanation
(Rhythm Pattern)
U001–256 (User),
P001–256 (Preset)
This selects the rhythm’s basic performance Style.
Grid 1/4, 1/8, 1/8L,
1/8H, 1/12,
1/16, 1/16L,
1/16H, 1/24
This sets the particular note division and resolution in a “single grid” used in creating the pattern in an
Rhythm Pattern, and how much of a “shuffle” syncopation is to be to applied (none/weak/strong) to it
(grid type).
1/4:
Quarter note (one grid section = one beat)
1/8:
Eighth note (two grid sections = one beat)
1/8L:
Eighth note shuffle Light (two grid sections = one beat, with a light shuffle)
1/8H:
Eighth note shuffle Heavy (two grid sections = one beat, with a heavy shuffle)
1/12:
Eighth note triplet (three grid sections = one beat)
1/16:
Sixteenth note (four grid sections = one beat)
1/16L:
Sixteenth note shuffle Light (four grid sections = one beat, with a light shuffle)
1/16H:
Sixteenth note shuffle Heavy (four grid sections = one beat, with a heavy shuffle)
1/24:
Sixteenth note triplet (six grid sections = one beat)
* Grid settings are shared with the arpeggio.
Duration
30–120%, Full This determines whether the sounds are played staccato (short and clipped), or tenuto (fully drawn out).
30–120:
For example, when set to “30,” the length of the note in a grid (or when a series of grids is
connected with ties, the final grid) is 30% of the full length of the note set in the grid type.
Full:
Even if the linked grid is not connected with a tie, the same note continues to sound until the
point at which the next new sound is specified.
* Duration settings are shared with the arpeggio.
* This has no effect if the Tone Env Mode parameter (p. 58) is set to “NO-SUS.”
Velocity
REAL, 1–127 Specifies the loudness of the rhythm pattern.
REAL:
If you want the velocity value of each note to depend on how strongly you play the keyboard,
set this parameter to REAL.
1–127:
If you want each note to have a fixed velocity regardless of how strongly you play the key-
board, set this parameter to the desired value.
Accent 0–100 When you play rhythm patterns, the velocity of each note is determined by the velocity of the notes pro-
grammed within the rhythm pattern. You can adjust the amount (“spread”) of this dynamic variation.
With a setting of “100,” the notes will have the velocities that are programmed by the rhythm pattern.
With a setting of “0,” all notes will be sounded at a fixed velocity.
* You can also use a REALTIME CONTROL knob to control this.
Fantom-Xa_e.book 96 ページ ２００４年１０月２２日 金曜日 午後２時３分
To Next Page
Loading...
