77
Creating a Performance
[PAGE] - [F6 (EXT)]
Parameter
Value Explanation
Bank Sel
(MSB)
0–127, OFF If you want a Bank Select number MSB (controller number 0) to also be transmitted when you switch Perfor-
mances, specify the value that you want to transmit (0–127) for each part.
If you do not want this message to be transmitted, set this to “OFF.”
* The data of the part for which the Keyboard Switch is turned off will not be transmitted.
Bank Sel
(LSB)
0–127 If you want a Bank Select number LSB (controller number 32) to also be transmitted when you switch Perfor-
mances, specify the value that you want to transmit (0–127) for each part.
The data of the part for which the Keyboard Switch is turned off will not be transmitted.
Prog 1–128, OFF If you want a Program Change number to also be transmitted when you switch Performances, specify the value
that you want to transmit (0–128) for each part.
If you do not want this message to be transmitted, set this to “OFF.”
* The data of the part for which the Keyboard Switch is turned off will not be transmitted.
Level
0–127, OFF If you want Volume messages to also be transmitted when you select a Performance, specify the desired value
(0–127) for the part.
If you do not want this message to be transmitted, set this to “OFF.”
* The data of the part for which the Keyboard Switch is turned off will not be transmitted.
Pan
L64–0–63R,
OFF
If you want Pan messages to also be transmitted when you select a Performance, specify the desired value (L64–
0–63R) for the part. If you do not want this message to be transmitted, set this to “OFF.”
* These messages will not be transmitted by parts whose Keyboard Switch is turned off.
Fantom-Xa_e.book 77 ページ ２００４年１０月２２日 金曜日 午後２時３分
To Next Page
Loading...
Need help?
General
