8
Updating the FANTOM-XR
1.
Insert the “FANTOM-XR Sample Tools Expansion Kit” CompactFlash card into the PC
card adapter.
fig.05-01
2.
Make sure that your Fantom-XR is switched OFF.
3.
Insert the PC card adapter (see step 1) into the Fantom-XR.
4.
Switch ON the power on your Fantom-XR.
After the opening movie is displayed, a caution regarding the update procedure will
appear.
* If the screen shown below does not appear, switch off the Fantom-XR’s power, and repeat the
operation from step 1.
fig.00-02_80
5.
Read the warning, and if you wish to proceed, press .
Press several times to view and read the entire message.
A screen will ask you for confirmation.
* If you wish to abort the update procedure at this point, press [EXIT], turn off the power, and remove
the PC card.
6.
Press [ENTER] to execute the update.
* Do not turn off the power while the update is in progress.
* The update will require approximately two minutes for completion.
7.
When the process has been completed, the display will indicate “Completed.”
Turn off the power of the Fantom-XR and remove the PC card.
This completes the update.
The next time you turn on the power, the FANTOM-XR Sample Tools Expansion will start up.
Keep this product in a safe place after you have completed the upgrade.
Update procedure
PC Card Adapter CompactFlash
Fantom-XR-V2_e.book 8 ページ ２００７年５月２２日 火曜日 午前１１時１分
To Next Page
Loading...
Need help?
General
