13
Chapter 1 Playing the Keyboard
When the following appears in the display
If there is any performance data stored in the FP-5’s memory, the following
appears in the display.
fig.01-03
Until you erase the performance data, you cannot play back an internal
song.
To erase the performance data and play back the internal song, press the
[Rec] button.
If you don’t want to erase the song, press the [Play/Stop] or [Song] button.
■
Listening to Each Part Separately
With the internal songs, you can select the performance part that is to be
played back.
You can also practice each hand separately while playing along with the
song.
1.
Select the song to be played back.
2.
Hold down the [Play/Stop] button and press either [Bass (1)]
button or [Chord(2)] button to select the part for which you
want the sound to not be played.
The indicator on the selected button goes out.
The performance data is assigned to the Track buttons as shown below.
fig.01-05
When you release the [Play/Stop] button, the song is played back.
The sound for the performance part selected in Step 2 is not played.
Temporarily preventing the sounds of a specified part from playing is called
“muting.”
3.
Hold down the [Play/Stop] button and press the button
selected in Step 2.
The sound of the muted part is then played.
4.
Press the [Play/Stop] button to stop playback.
flash in red
Right-hand
Part
Left-hand
Part
Changing the song cancels
the mute setting.
FP-5_e.book 13 ページ ２００５年１月２６日 水曜日 午前１０時２２分
To Next Page
Loading...
Need help?
General
