24
Advanced Operation
Saving a Registration Set (Registration Set Export)
Here’s how the registration set that’s saved in this unit can be saved to a
USB ash drive.
* If you’re saving to a USB ash drive, connect your USB ash drive to the
USB Memory port before proceeding.
1. Press the [Function] button.
2. Use the [K] [J] buttons to select “Reg. Set Export.”
3. Press the [Function] (Enter) button.
The Reg. Set Export screen appears.
4. Renaming the registration set.
Button Operation
[K] [J] button
Select the character to change.
[-] [+] buttons Change the character.
Insert one character
Press the [s] button.
Delete one character
Press the [t] button.
If you decide to cancel, press the [Exit] (Exit) button.
5. Press the [Function] (Enter) button.
The registration set is saved.
NOTE
Never turn o the power or remove the USB ash drives while the
screen indicates “Executing....”
6. Press the [Exit] button several times to exit Function mode.
Loading a Saved Registration Set (Registration Set
Import)
Here’s how a registration set saved on a USB ash drive can be loaded into
the registrations of this unit.
* If you want to load a registration set from a USB ash drive, connect
your USB ash drive to the USB Memory port before proceeding.
NOTE
Note that when you load a registration set, it will overwrite (and erase) all
of the registrations already in registration memory. If you wish to retain
your existing registrations, save them to a USB ash drive.
1. Press the [Function] button.
2. Use the [K] [J] buttons to select “Reg. Set Import.”
3. Press the [Function] (Enter) button.
The Reg. Set Import screen appears.
4. Use the [–] [+] buttons to select the registration set you
want to load.
5. Press the [Function] (Enter) button.
A conrmation message appears.
If you decide to cancel, press the [Exit] (Exit) button.
6. Use the [J] button to select “Yes,” and then press the
[Function] (Enter) button.
The registration set will be loaded.
NOTE
Never turn o the power or remove the USB ash drives while the
screen indicates “Executing....”
7. Press the [Exit] button several times to exit Function mode.
To Next Page
Loading...
Need help?
General
