62
Recording a Layered Performance (Looper)
Start Overdubbing
Overdub Overdub/
Repeated playback
Overdub
Intro
Main
Ending
1. Press the LOOPER [START/STOP] button.
The LOOPER [START/STOP] button will light, and the intro will start overdubbing.
The looper rhythm will also begin sounding at the same time.
Highlighted while the main section is playing
Shown if a recorded performance exists
Looper Rhythm Name
Currently playing chord
Chord to be played next
Tempo
Looper Rhythm Number
Time signature
Currently playing location
Highlighted while the intro section is playing
Highlighted while the ending section is playing
When the intro has nished being overdubbed, overdubbing of the main section will start.
The main section will continue being overdubbed for the number of measures of the Looper rhythm.
2. Press the LOOPER [OVERDUB] button.
The LOOPER [OVERDUB] button will light, and repeated playback will begin.
Pressing the LOOPER [OVERDUB] button toggles you between overdubbing and repeated playback.
3. Press the LOOPER [START/STOP] button.
The ending will be overdubbed, and then overdubbing will stop.
If you want to stop immediately, press the LOOPER [START/STOP] button.
* If you stop during overdubbing, part of the phrase might not be preserved.
MEMO
• If you’re not satised with the phrase you recorded, and would like to re-record it, erase the phrase as described in “Erasing a Phrase” (p. 63).
• If you assign the pedal function to “Looper Start/Stop” or “Looper Overdub,” you’ll be able to operate the Looper using the pedal (p. 73).
• You can save the recorded phrase in USB memory (p. 80) and use it with the Audio Key function (p. 31).
To Next Page
Loading...
Need help?
General
